EC2ND/EE2ND Series Data
| | | | | | | | | |
Switching Capacity
Coil Temperature Rise
Operate Time
Release Time Without Diode
Release Time With Diode
Running Specifications (Noload)
Running Specifications (Load)
Breakdown Voltage
Magnetic Interference
TUBE PACKAGE (EC2ND, EE2ND)
| Dimension of Package (Unit : mm)
Outline of Package
|
Tape Package (EE2ND)
APPEARANCE
TAPE DIMENSION mm (inch)
Relay orientation mark and tape carrying direction.
Soldering Temperature Condition
Through–hole mounting type (EC2ND)
 |
Automatic soldering |
|
* Preheating |
: 100°C max. 1 minute max. |
|
* Solder temperature |
: 250°C max. |
|
* Solder time |
: 10 seconds max. |
 |
Manual soldering |
|
|
* Solder temperature |
: 350°C max. |
|
* Solder time |
: 3 seconds max. |
Surface mounting type (EE2ND)
IRS Method
VPS Method
Note
| 1. |
Temperature profile shows printed circuit board surface temperature on the relay terminal portion. |
| 2. |
Check the actual soldering condition to use other method except above mentioned temperature profiles. |
Guide to Applications
| 1. |
When connecting coils, refer to the pin configuration to prevent misoperation or malfunction. |
| 2. |
The latch type relay should be initialized at the appointed position (set or reset position) when using, and should be energized or deenergized to the specified polarity to avoid wrong operations by reversed contact state. |
| 3. |
Ultrasonic cleaning is not recommended to keep contact performance reliable. Alcohol based solvents are available as proper solvents. |
| 4. |
Pressurized stress on the relay cover may affect reliable operation. |
| 5. |
Minimum contact load of the relay is 10 mVdc, 10 µA. This value is a reference value in the resistance load. Minimum capacity changes depending on switching frequency and environment temperature and the load. |
|
